Pickup Tail Light Bar, 41" High Bright LED Third Brake Signal Light Red, Waterproof Flashing DRL Drive Light Brake Tail Reverse Light - Universal for 12V Cars Trucks Vans Pickups SUVs

No special too, no drilling or screws required.
Easy to Install, double side adhesive tape available for installation.
Super bright LED, energy-saving, long life, over 50,000 working hours.
High temperature resistant, more security, and stability.
LED lights less heat radiation, low power consumption.
Wiring Connect:
Red Line-ACC V+
Black line-VCC V-
Yellow line/L-Left Turn V+
Yellow line/R-Right Turn V+
White Line-Brake V+
Green line-Width Lamp V+

Type: Rear Windshield LED Third High Brake Light Tail Lamp
Voltage: DC12V
Light Source: LED
Color: Red
Length: Approx. 103cm/40.6inch
Fitment: for all most Cars
Waterproof: Yes, IP68
Functions: Brake + DRL Drive light+ Turn Signal; With Flash, Flow Modes
How to Install:
1. Please use detergent or alcohol to clean the surface of the target area before you stick it on.
2. Use the hairdryer to heat the tape a little.
3. Stick it on and keep your car non-washed. within 48 hours to achieve the best adhesiveness.
4. Try to finish the steps one time, do not peel off from one area and stick on another area to avoid bad adhesiveness.
Note:
Please measure your rear window size before you buy this product. This item is approx 103cm/40.6inch.

Product Includes:
1 x Rear Windshield LED Third High Brake Light Tail Lamp

⚠️WARNING: This product contains chemicals known to the State of California to cause cancer and birth defects or other reproductive harm. www.p65warnings.ca.gov

Q1: What tools are required for installation?
A1: No special tools are required. The LED light is installed using double-sided adhesive tape, which is included.

Q2: What are the functions of this LED tail lamp?
A2: The LED tail lamp functions as a brake light, daytime running light (DRL), and turn signal light. It includes flash and flow modes for enhanced visibility.

Q3: How do I install the LED tail lamp?
A3: Clean the target surface with detergent or alcohol, heat the adhesive tape with a hairdryer, then stick the lamp onto the surface. Avoid washing the car for 48 hours for optimal adhesiveness.

Q4: What are the wiring connections for the LED tail lamp?
A4:

Red Line: ACC V+
Black Line: VCC V-
Yellow Line/L: Left Turn V+
Yellow Line/R: Right Turn V+
White Line: Brake V+
Green Line: Width Lamp V+
Q5: Is the LED tail lamp waterproof?
A5: Yes, the LED tail lamp is waterproof with an IP68 rating, making it suitable for various weather conditions.